NR-11
by Brushing on Brass, Copper, or BronzeNR-11 imparts an Orange Rust Finish upon Brushing or Dipping.
Brass or Copper Parts should be thoroughly cleaned and prepped prior to usage.
Directions:
- Prepare the Surface by brushing SURCLEAN-400 or BRUSH N CLEAN to degrease and descale.
- Rinse with Water. Ensure no cleaning solution remains on surface.
- Brush NR-11 on Surface until Surface is entirely covered. Pay attention to edges and hard to reach areas.
- Let Part sit for 1-2 hours to for an orange finish to develop. For better results, let the part sit for 12 hours to fully develop. Rinse with water and air dry the part.
- When part is completely dry and the rusting is complete, Seal the surface with an appropriate Lacquer for Metal.
Recommended Ancillary Products:
- SURCLEAN-400 Metal Conditioner
- Acrylaq-1045 FLAT Lacquer for Metal
Square Footage : Approximately 90-100 Square Feet Per Gallon
Size | Square Feet |
8 oz Bottle | 6-8 |
1 Gallon | 90-100 |
4 Gallon Case | 360-400 |
5 Gallon Bucket | 450-500 |
Share This