Steel Etch

Steel Etch imparts an aggressive Rust Finish upon Brushing or Dipping.

Steel Parts should be thoroughly cleaned and prepped prior to usage.

Directions:

1. Prepare the Steel Surface by brushing SURCLEAN-400 to degrease and descale.
2. Brush Steel etch on Surface until Surface is entirely covered.   Pay attention to edges and hard to reach areas.  Immediately upon brushing/dipping, a dull gray tone will develop
3. Let Part sit for 3-5 days to develop an aggressive rust finish.  
4. When part is completely dry and the rusting is complete, Seal the surface with an appropriate Lacquer for Metal.

Recommended Ancillary Products:

1. SURCLEAN-400 Metal Conditioner
2. Acrylaq-1045 FLAT Lacquer for Metal

Square Footage : Approximately 90-100 Square Feet Per Gallon