Dark Brown Rust DB-10

DB-10 imparts a Dark Brown Rust Finish upon Brushing or Dipping.

Steel Parts should be thoroughly cleaned and prepped prior to usage.

Directions:

1. Prepare the Steel Surface by brushing SURCLEAN-400 to degrease and descale.
2. Rinse with Water.  Ensure no cleaning solution remains on surface.
3. Brush DB-10 on Surface until Surface is entirely covered.  Pay attention to edges and hard to reach areas.  Initially a pink/red finish develops.  Add more Solution to your surface and brush vigorously until part beings to darken.  After darkening begins, let the part sit.
4. Let Part sit for 3-5 Minutes for the finish to become more brown.
5. Rinse with Water.  Ensure no Patina remains on surface.
6. Let the Part remain wet/moist while drying.  The wet areas will develop a yellow rust within 1-2 hours. 
7. After yellow rust develops.  Using a wet sponge or cloth, selectively remove yellow rust to highlight the part.
8. Air dry the part.
9. Seal Patina with an appropriate Lacquer for Metal.

Recommended Ancillary Products:

1. SURCLEAN-400 Metal Conditioner
2. Acrylaq-1045 FLAT Lacquer for Metal

Directions:

1. Prepare the Steel Surface by brushing SURCLEAN-400 to degrease and descale.
2. Rinse with Water.  Ensure no cleaning solution remains on surface.
3. Brush Rusty Red on Surface until Surface is entirely covered.   Pay attention to edges and hard to reach areas.  Immediately upon brushing/dipping, a pink red finish will develop. 
4. Let Part sit for 1 hour to for the pink finish to become a Red Rust Finish.  For better results, let the part sit for 12 hours.
5. When part is completely dry and the rusting is complete, Seal the surface with an appropriate Lacquer for Metal.

Recommended Ancillary Products:

1. SURCLEAN-400 Metal Conditioner
2. Acrylaq-1045 FLAT Lacquer for Metal

Square Footage : Approximately 90-100 Square Feet Per Gallon